Open Gear Lubrication for Kiln Girth Gears, Mills and Draglines

17.11.26 11:50 AM

In short: large open gears on cement kilns, ball and SAG mills, draglines and shovels run under heavy load at low speed with no gear case to hold an oil bath. They rely on a thin film of special open gear lubricant, applied by an automatic spray system, to protect the teeth. Choosing the right lubricant, setting the spray correctly and checking the gear mesh with thermography and contact patterns prevents pitting, scuffing and very expensive gear replacements. BTGC supplies Bel-Ray open gear and mining lubricants.

Cement kiln area equipment

A girth gear on a cement kiln or mill can take months to replace and costs a great deal. Cement plants and mines in the Kingdom also face high temperatures and dust, which make open gear lubrication harder.

Types of open gear lubricant

TypeNotes
Asphaltic compounds with solventOlder technology; heavy build-up and solvent handling concerns
Greases with solid lubricantsSemi-fluid products with graphite or molybdenum disulphide for heavy load protection
Fully synthetic open gear fluidsClean, sprayable films with low consumption and good temperature tolerance

Running-in, operation and repair

  • Running-in lubricants help new or re-aligned gears bed in and polish the tooth contact.

  • Operational lubricants protect the gears in normal running at the lowest consumption.

  • Repair lubricants can help restore surfaces with light pitting or scuffing during a planned programme.

  • Follow the gear maker and lubricant supplier guidance for each phase.

Mining process plant

Checks that catch problems early

  • Check the spray pattern: the full face width must be covered on every spray cycle.

  • Use thermography across the gear face; a large temperature difference from one side to the other points to misalignment or poor lubrication.

  • Inspect the contact pattern and lubricant film colour during stops.

  • Watch for build-up in tooth roots, which can lift the gear and cause shock loads.

  • Keep spray nozzles, air supply and lubricant tanks clean and protected from dust.

Bel-Ray from BTGC

Bel-Ray, a Calumet brand, makes open gear lubricants, greases, wire rope lubricants and food-grade lubricants for mining and heavy industry. BTGC is the Bel-Ray partner in Saudi Arabia alongside Royal Purple. See also synthetic gear oil for shock loads, lower cost of ownership with premium lubrication and the mining and metals sector page.

Questions buyers ask

How often should the spray system fire? It depends on gear size, speed and lubricant; set it from the supplier's recommendation and adjust using inspection results.

Can I switch from an asphaltic product to a synthetic one? Yes, usually after cleaning the old build-up from the gears; follow a planned changeover.

Does BTGC support gear inspections? Yes, with lubricant recommendations and thermography-based checks.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.