Strip Thickness Gauges in Rolling Mills: X-Ray or Isotope Measurement

17.11.26 10:32 AM

In short: in hot and cold rolling mills, thickness gauges measure the strip continuously and feed the automatic gauge control that adjusts the roll gap. Most use radiation: the strip absorbs part of an X-ray or isotope beam, and the detector converts the remaining intensity into thickness. X-ray gauges can be switched off and have fast response; isotope gauges are very stable but always radiate and need source licensing. Accuracy depends on alloy compensation, temperature correction and regular standardisation. BTGC supplies IMS Messsysteme measuring systems.

IMS C-frame strip thickness gauge

Steel and aluminium rolling mills in the Kingdom, including flat-rolled steel and aluminium sheet producers, rely on thickness, width, profile and flatness measurement to meet customer tolerances and reduce scrap. A gauge that drifts can send a whole coil out of tolerance before anyone notices.

X-ray and isotope gauges compared

FeatureX-ray gaugeIsotope gauge
Radiation sourceX-ray tube, switched off when not measuringRadioactive source, always active (shuttered)
Response timeVery fastFast, slightly lower count rates
StabilityNeeds high-voltage stability and regular standardisationVery stable source; slow decay is compensated
LicensingRadiation equipment licenceRadioactive source licence, transport and disposal rules
Typical useMost modern hot and cold millsOlder installations and some thick-strip duties

What affects accuracy

  • Alloy composition: different alloys absorb radiation differently, so alloy compensation tables must be correct.

  • Strip temperature in hot mills: thermal expansion and scale affect the reading; temperature correction is applied.

  • Water, oil and steam in the beam path, especially in cold mills; air purging keeps windows clear.

  • Pass line height and strip tilt within the measuring gap.

  • Standardisation with reference samples at regular intervals or between coils.

Steel strip in a rolling mill

Safety and maintenance

  • Follow the national radiation protection rules for licensing, controlled areas, interlocks and dosimetry.

  • Check shutters, warning lights and interlocks regularly.

  • Keep C-frames cool and clean; cooling water and purge air failures cause drift.

  • Track standardisation results to spot ageing tubes or detectors before they fail.

  • Keep spare detectors and high-voltage parts for critical mills.

IMS Messsysteme from BTGC

IMS Messsysteme of Germany supplies thickness, width, profile, flatness and surface measuring systems for hot and cold rolling mills and processing lines. BTGC is the IMS partner in Saudi Arabia. See also the metal sector and mining and metals sector pages.

Questions buyers ask

Can an isotope gauge be replaced with an X-ray gauge? Usually yes; many mills have switched to X-ray to avoid source licensing, transport and disposal.

How often are thickness gauges standardised? Often automatically between coils or at set intervals, plus periodic checks with certified samples.

Does IMS measure more than thickness? Yes, also width, profile, flatness, surface defects and coating weight.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.