Choosing Industrial Vacuum Pumps: Dry Screw, Rotary Vane or Liquid Ring

17.11.26 11:54 AM

In short: vacuum is used for distillation, drying, degassing, solvent recovery, transformer oil treatment and many laboratory and packaging tasks. The right pump depends on the pressure needed, the pumping speed at that pressure, and above all what the process gas contains: condensable vapours, corrosive gases or particles. Oil-sealed rotary vane pumps are economical for clean duties, dry screw pumps handle process vapours without contaminating oil, liquid ring pumps tolerate wet gas, and Roots boosters raise speed at lower pressures. BTGC supplies Leybold vacuum pumps and systems.

Leybold vacuum pumps range

Chemical and petrochemical plants, pharmaceutical producers, food packers, transformer workshops and laboratories in the Kingdom all use vacuum pumps. Many problems come from pumps chosen for clean air but used on process vapours.

Main pump types

TypeStrengthsWatch out for
Oil-sealed rotary vaneLow cost, good ultimate vacuum for clean gasesOil contamination by vapours; needs gas ballast and oil changes
Dry screwNo oil in the pumping chamber, handles condensable and many corrosive vapoursHigher first cost; temperature management
Liquid ringTolerates wet, saturated gas and some liquid carry-overLimited vacuum set by liquid vapour pressure; uses seal liquid
Roots boosterIncreases pumping speed at lower pressures when combined with a backing pumpNeeds a suitable backing pump
TurbomolecularHigh and ultra-high vacuum for labs and instrumentsNot for rough process duties

Selection data

  • Operating pressure and the pumping speed needed at that pressure, not only the ultimate vacuum.

  • Gas composition: water vapour, solvents, acids, particles and any flammable components.

  • Pump-down time and leak rate of the system.

  • Hazardous area classification and explosion protection requirements.

  • Cooling, noise and space limits, especially in hot plant rooms.

Chemical reactor in a process plant

Maintenance tips

  • On oil-sealed pumps, use gas ballast to prevent vapour condensing in the oil, and change oil when it darkens or thins.

  • Fit inlet filters or traps where particles or liquids can reach the pump.

  • Check exhaust filters and back pressure regularly.

  • Monitor pump temperature and current; a rise often shows process deposits or wear.

  • Plan overhauls on dry pumps using hours and condition data.

Leybold from BTGC

Leybold of Germany makes dry screw, rotary vane, Roots and turbomolecular vacuum pumps and complete vacuum systems. BTGC is the Leybold partner in Saudi Arabia. See also transformer oil handling and the rotating equipment page.

Questions buyers ask

Why does my rotary vane pump oil turn milky? Water vapour is condensing in the oil; use gas ballast, change oil and consider a dry pump for wet duties.

Is a dry pump always better? Not always. For clean, light duties a rotary vane pump is often the most economical choice.

Does BTGC supply service kits? Yes, genuine Leybold oils, filters and service kits.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.