Wear Protection in Cement Plants: Where Bimetallic Parts Pay Off

17.11.26 02:10 PM

In short: cement plants grind and move huge tonnages of abrasive material: limestone, clay, sand, iron ore, gypsum and clinker. Wear eats into loader buckets, crusher hoppers, chutes, transfer points, separators and clinker handling, and each repair means a stop. Bimetallic wear parts, with a very hard white iron face on a weldable steel backing, last much longer than ordinary wear plate where sliding abrasion dominates. Knowing where to use them, and where tougher materials are better, cuts maintenance costs. BTGC supplies Bimat bimetallic wear parts.

Cement kiln area equipment

The Kingdom has many large cement plants supplying construction and giga-projects. Long production campaigns and high summer temperatures make reliable wear protection important.

Wear hot spots in a cement plant

AreaTypical wear and option
Quarry loaders and haul equipmentSliding abrasion on bucket floors and lips; bimetallic chocky bars and wear buttons
Crusher feed hoppers and chutesImpact and abrasion; tough plate at impact points, bimetallic parts where material slides
Transfer chutes and conveyor skirtsSliding abrasion; bimetallic liners or ceramics
Raw mill and separator partsAbrasion from fine particles; suitable hard liners
Clinker chutes and coolersAbrasion with high temperature; heat-resistant wear materials

Choosing the right protection

  • Identify the wear mechanism: sliding abrasion, impact or both, and the temperature.

  • Use bimetallic parts where material slides, and tougher plate where large lumps strike.

  • Allow for heat: very hot clinker zones may need special heat-resistant materials.

  • Let material build up in pockets where possible so it protects the steel.

  • Standardise part sizes to keep stock simple.

Bulk materials stockyard

Measuring success

  • Record wear life for each location before and after changes.

  • Compare cost per tonne including downtime, not only part price.

  • Inspect at fixed intervals and measure remaining thickness.

  • Share results across lines and plants to roll out what works.

Bimat from BTGC

Bimat of Germany supplies bimetallic wear parts for mining, earthmoving, cement and bulk handling equipment. BTGC is the Bimat partner in Saudi Arabia. See also bimetallic wear parts for buckets and chutes, alternative fuel handling for cement kilns and the mining and metals sector page.

Questions buyers ask

Can bimetallic parts be used in hot clinker zones? They have temperature limits; check the maker's data for the actual temperature.

Where should I start? At the locations with the most frequent repairs and the highest downtime cost.

Can BTGC suggest a layout for our chutes? Yes, from drawings, photos and wear history.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.