Centrifugal Pump Spare Parts: Wear Rings, Impellers and Seals

18.11.26 03:03 PM

In short: most centrifugal pump repairs need the same few parts: wear rings, bearings, mechanical seals and gaskets, and sometimes an impeller or shaft. Keeping the right parts on site turns a long outage into a short repair. A spares plan looks at how critical each pump is, whether a standby exists, how many identical pumps the plant runs and how long each part takes to make. BTGC supplies Akay pumps and spare parts.

Akay API 610 process pump

Refineries, gas plants and petrochemical units in the Kingdom run hundreds of pumps, many of them identical, which makes shared spares worthwhile.

Typical spare parts

PartWhy it is neededComments
BearingsMost common wear itemHold sets for each frame size
Mechanical sealsLeaks and seal failuresHold complete cartridges for critical pumps
Wear ringsClearance grows with wear, cutting efficiencyReplace when clearance doubles or per OEM limits
ImpellerErosion, cavitation or corrosionLong lead time for special alloys
Shaft and sleevesBent or worn shaftsHold for critical single pumps
Gaskets and O-ringsNeeded at every openingLow cost; hold full sets

Building the plan

  • Rank pumps by consequence of failure and whether a spare pump is installed.

  • Group identical pumps so one set of spares covers several units.

  • Ask for interchangeability lists when buying new pumps.

  • Include rotor assemblies for critical between-bearing pumps, to cut repair time.

Refinery pump area in Saudi Arabia

Storage and records

  • Store shafts and rotors supported horizontally or hung vertically to avoid bending.

  • Keep seals and bearings in original packaging, dry and cool.

  • Record wear ring clearances at each overhaul to predict the next.

  • Clean up stock records with asset cataloging and supply chain services.

  • Check NPSH and operating point when impellers keep failing; see NPSH and cavitation.

Akay from BTGC

Akay supplies API 610 and chemical process pumps with wear rings, impellers, shafts and seal support. BTGC supplies Akay pumps in Saudi Arabia with spare parts. See also API 610 pump types and the rotating equipment page.

Questions buyers ask

When should wear rings be replaced? Typically when the clearance reaches about twice the new value, or as the OEM advises.

Should every pump have a spare impeller? No; focus on critical pumps without standby and on long-lead alloys.

Can BTGC quote spares from the pump serial number? Yes, send the nameplate and data sheet.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.