In short: most cooling tower fans are driven through a right-angle gearbox inside the hot, wet fan stack, where it is hard to reach and easy to forget. Oil leaks, water in the oil and misaligned drive shafts are the usual causes of failure. Sizing the gearbox with a cooling tower service factor, checking whether it can run at low speed on a variable speed drive, and making oil checks possible from outside the stack make a big difference to reliability. BTGC supplies Hansen cooling tower gear units.

Power plants, refineries, petrochemical complexes, district cooling plants and large buildings in the Kingdom depend on cooling towers, and one failed fan drive in summer can cut plant output.
Selection points
Use the cooling tower industry practice for gear reducers: CTI STD-111 calls for a service factor of at least 2.0 on motor nameplate power.
Ratio and output speed to suit the fan diameter and tip speed.
If the fan runs on a variable speed drive, confirm the gearbox lubrication works at the lowest speed; splash lubrication may need an auxiliary pump.
Seal design that prevents oil leaking out and moisture getting in.
Mounting and shaft details that match the existing fan, drive shaft and motor.
Common problems and remedies
| Problem | Remedy |
|---|---|
| Oil leaks at seals | Upgrade to improved or dry-type seal systems and keep breathers clear |
| Water in oil | Use desiccant or sealed breathers and check oil samples |
| Low oil level unnoticed | Fit remote oil level gauges and drains outside the fan stack |
| Bearing and gear damage | Correct drive shaft and coupling alignment; balance the fan |
| Overheating in summer | Check oil grade, level and fan loading |

Maintenance routine
Check oil level and look for leaks on every round; use remote gauges to avoid entering the stack.
Sample oil for water and wear metals at fixed intervals.
Fit and test vibration switches or sensors to protect the fan and gearbox.
Check drive shaft and coupling alignment after any work on the motor or gearbox.
Plan gearbox overhauls in the cooler months when towers can be taken out of service.
Hansen from BTGC
Hansen Industrial Transmissions of Belgium, part of the Sumitomo Drive Technologies group, makes industrial gear units including the P4 and M4 ranges used on cooling towers. BTGC is the Hansen partner in Saudi Arabia. See also cooling tower performance, closed circuit cooling towers, Baltimore Aircoil and the power and utilities sector page.
Questions buyers ask
Can a cooling tower gearbox run on a VFD? Usually, if lubrication is adequate at the lowest speed; check with the gearbox data.
Why do cooling tower gearboxes leak oil? Heat, moisture and pressure changes stress the seals; breather condition and seal design are key.
Does BTGC supply replacement gearboxes for other brands? Yes, Hansen units can often replace existing gearboxes with matching dimensions.
Contact BTGC
Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.