Crane Wheel Wear: Causes, Limits and Replacement

16.11.26 09:06 AM

In short: crane wheels should wear slowly and evenly on the tread. Fast flange wear, noise and skewing mean the crane is not running straight, and replacing the wheel alone will not fix it. Material, hardness, alignment and rail condition all matter. BTGC supplies Gosan forged crane wheels, sheaves and hook blocks for Saudi steel plants, ports and workshops.

Gosan forged crane wheel

Overhead cranes in a melt shop, a coil yard or a port container terminal travel thousands of kilometres a year. Their wheels carry the full load on a contact patch smaller than a coin. When everything is aligned, the tread wears slowly. When something is off, the flanges grind against the rail, the crane skews on its runway and wheels that should last years last months.

Reading the wear pattern

PatternLikely cause
Even tread wearNormal service
Heavy wear on one flangeWheel or end carriage misalignment, or rail span out of tolerance
Flange wear on both sides of one axleSkewing; drive speeds not matched or one wheel larger than the other
Spalling and pits on the treadOverload, wheel too soft for the load, or poor heat treatment
Rapid wear on all wheelsRail head damage, wrong rail profile or contamination

Wear limits and replacement

  • Replace wheels when flange thickness or tread diameter reaches the crane maker's limit, and replace them in matched pairs on driven axles so the diameters are equal.

  • Check rail span, straightness and level along the full runway before fitting new wheels.

  • Use forged and hardened wheels with the right hardness for the rail; a wheel much harder than the rail transfers wear to the runway.

  • Record the wear and replacement dates so the next interval can be predicted.

Crane hook block with sheaves and wire rope

Gosan from BTGC

Gosan manufactures forged crane wheels, sheaves, hook blocks and laminated hooks for crane makers and heavy industry. BTGC is the Gosan partner in Saudi Arabia. See also sheaves and wire rope life, laminated ladle hooks and the mining and material handling page.

Questions buyers ask

Can Gosan make wheels to our existing drawing? Yes; wheels are made to the crane's dimensions, bore and bearing arrangement.

Should we replace one wheel or a pair? Driven wheels should be replaced in pairs on the same axle line so their diameters match.

What hardness should the wheel have? It depends on the rail and the load; Gosan selects material and hardness to suit the application.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.