In short: a cycloidal reducer turns a fast input into slow output with an eccentric that drives cycloid discs around a ring of pins. Many teeth share the load at once and most parts work in rolling contact, so cycloidal units take shock loads that would damage ordinary gear teeth, and they reach high ratios in one compact stage. Helical and bevel-helical gear units are often more efficient at lower ratios and very high powers. Choosing between them depends on load type, ratio, efficiency and space. BTGC supplies Sumitomo Cyclo reducers and gearmotors.

Conveyors, feeders, crushers, mixers, cranes and water treatment drives in the Kingdom often run with shock loads, frequent starts and dust. Gear failures on these drives stop production and can damage connected equipment.
How a cycloidal reducer works
An eccentric bearing on the input shaft drives one or more cycloid discs.
The discs roll around a ring of pins and turn slowly in the opposite direction.
Pins in holes in the discs transfer the slow rotation to the output shaft.
A large share of the disc lobes are in contact at any moment, spreading the load.
Cycloidal or helical?
| Point | Cycloidal | Helical and bevel-helical |
|---|---|---|
| Shock loads | Very high momentary overload capacity | Must be sized with higher service factors |
| Ratio per stage | High ratios in one stage | Several stages for high ratios |
| Size and weight | Compact for high ratios | Larger at high ratios |
| Efficiency | Good, slightly lower at high ratios | Very high, especially at lower ratios |
| Typical use | Conveyors, feeders, mixers, crushers, cranes | Large continuous drives, high powers |

Sizing and maintenance
Size with a service factor that reflects the load type, starts per hour and daily running hours.
Check output shaft radial loads from sprockets, pulleys and couplings.
Use the correct lubricant and change intervals; grease-lubricated units still need periodic regreasing or replacement.
Inspect seals regularly in dusty sites and keep breathers clean.
Trend vibration and temperature to plan repairs before failure.
Sumitomo from BTGC
Sumitomo Drive Technologies, part of Sumitomo Heavy Industries, makes Cyclo reducers, gearmotors and industrial gear units, and owns Hansen Industrial Transmissions. BTGC is the Sumitomo partner in Saudi Arabia. See also cooling tower gearboxes, gear oil for shock loads and the machinery handling page.
Questions buyers ask
Can a Cyclo unit replace an existing gearbox? Often yes, with adapters for mounting and shafts; BTGC can check dimensions and ratings.
Why are cycloidal units good with shock loads? Many lobes share the load at once and the parts work mainly in rolling contact.
Does BTGC stock Cyclo units? Common sizes and spare parts are available with short lead times.
Contact BTGC
Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.