Gear Reducer Oil Leaks: Seals, Breathers and Fixes

18.11.26 02:59 PM

In short: an oil leak from a reducer is more than a mess: it means oil is being lost, dirt can get in and a seal or breather has a problem. Most leaks come from worn or damaged shaft seals, blocked breathers that let pressure build as the unit heats, overfilling, or the wrong mounting position oil level. Fix the cause, not just the seal. BTGC supplies Sumitomo Cyclo drives, gearmotors and parts.

Sumitomo Cyclo gearmotors

Gearmotors on conveyors, clarifiers, mixers and screens in Saudi plants run hot in summer, which makes leaks more common.

Common causes

CauseSigns
Worn shaft sealOil at the output or input shaft; grooved shaft surface
Blocked or missing breatherLeaks appear when the unit is hot; pressure at the fill plug
OverfillingOil pushed out of seals and breather
Wrong oil level for mounting positionUnits mounted differently from the order
Loose covers or plugsOil at joints and drain plugs

Fixing leaks properly

  • Check that the oil level matches the mounting position on the nameplate.

  • Clean or replace the breather, and move it to the highest point if the unit was remounted.

  • Replace seals with the correct size and material, and repair or sleeve a grooved shaft.

  • Use the oil grade and viscosity recommended for the ambient.

  • For grease-lubricated Cyclo units, follow the regreasing amounts; over-greasing also causes leaks.

Water treatment and desalination plant

Preventing repeat leaks

  • Protect seals from dust with shields or V-rings in dirty areas.

  • Avoid pressure washing directly at seals.

  • Check temperatures in summer; a unit running very hot may be overloaded; see gearmotor sizing.

  • Record leaks and fixes to spot units that keep failing.

Sumitomo Drive from BTGC

Sumitomo Drive Technologies makes Cyclo drives and gearmotors. BTGC supplies Sumitomo Drive in Saudi Arabia with replacement units and parts. See also gearmotors for water treatment and the lubrication and reliability page.

Questions buyers ask

Can I just add sealant to stop a leak? No; find and fix the cause, or the leak will return.

Why does a reducer leak only when hot? Usually a blocked breather or overfilling, as air and oil expand with heat.

Does BTGC supply seal kits? Yes, for Sumitomo units based on the nameplate.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.