In short: hydraulic and lube oil systems turn part of their power into heat, and oil coolers must remove it to keep oil within its working temperature. Air-cooled coolers need no water but can only cool oil to somewhat above ambient, which is a challenge at 50 degC. Water-cooled coolers reach lower temperatures but need clean cooling water and carry a risk of water entering the oil. Correct sizing, thermostatic bypass and regular cleaning keep oil temperatures under control. BTGC supplies Rex finned tube coolers and oil coolers.

Hydraulic presses, mobile and mining equipment, compressor and turbine lube systems and gearboxes in the Kingdom often run hot in summer, shortening oil and seal life.
Air-cooled vs water-cooled
| Factor | Air-cooled | Water-cooled |
|---|---|---|
| Cooling medium | Ambient air with fans | Plant cooling water |
| Lowest oil temperature | Ambient plus approach | Close to water temperature |
| Water risk | None | Leaks can contaminate oil |
| Maintenance | Fin cleaning, fans | Tube cleaning, water treatment |
| Best for | Remote and water-scarce sites | Plants with good cooling water |
Sizing points
Calculate heat load from system power and efficiency, not just pump size.
Use the real maximum ambient or water temperature.
Allow for fouling and dust on fins.
Fit thermostatic bypass valves so cold oil bypasses the cooler at start-up.
Check pressure drop limits for the oil circuit.

Maintenance tips
Clean fins regularly from the clean side outward.
Check fans, belts and motors.
Watch oil temperatures and the difference across the cooler.
Test water-cooled units for leaks and check oil for water.
Keep oil clean; see hydraulic oil in hot climates.
Rex from BTGC
Rex Heat Exchanger of India makes radiators, finned tube coolers, intercoolers and aftercoolers for generator sets, transformers, motors and compressors. BTGC is the Rex partner in Saudi Arabia. See also generator set radiators, lube oil systems and the power and utilities sector page.
Questions buyers ask
Can an air-cooled cooler cool oil below ambient? No, it can only cool to somewhat above the ambient air temperature.
Why fit a thermostatic bypass? It lets cold oil warm up quickly and protects the cooler from high pressure at start-up.
Does BTGC supply replacement oil coolers? Yes, Rex coolers built to fit existing systems.
Contact the BTGC power division
Email power@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.