In short: large compressors, steam turbines and gearboxes depend on a pressurised oil system to feed their bearings and seals. If oil pressure drops, the machine trips; if oil is dirty or hot, bearings wear. These systems, often built to API 614, include main and standby pumps, coolers, filters, accumulators and controls. Reliable screw or gear pumps, clean oil and tested standby changeover are the heart of a dependable system. BTGC supplies Arai screw and rotary plunger pumps.

Gas plants, refineries, petrochemical complexes and power plants in the Kingdom run many critical machines with lube and seal oil consoles. Console problems are a frequent cause of spurious trips.
Main components
| Component | Role |
|---|---|
| Main and standby pumps | Shaft-driven or motor-driven pumps, usually screw or gear pumps, with automatic standby start |
| Coolers | Keep oil temperature in range; twin coolers allow changeover |
| Duplex filters | Remove particles; switch without stopping flow |
| Pressure control valves | Hold header pressure steady |
| Rundown tank or accumulator | Keeps bearings fed during coast-down after a trip |
| Instruments | Pressure, temperature, level and differential pressure alarms and trips |
Reliability practices
Test standby pump auto-start regularly with a controlled pressure drop.
Change filters on differential pressure, and keep spare elements on site.
Keep oil clean and dry; sample it regularly; see varnish prevention.
Check pump relief valves and couplings, and trend pump vibration and noise.
Keep coolers clean so oil temperature stays in range in summer.

Pump selection for consoles
Screw pumps give smooth, low-pulsation flow and long life with lubricating oils.
Size pumps for full flow with margin, including seal oil demand where combined.
Design for the oil viscosity at cold start as well as running temperature.
Follow API 614 and the machine maker's requirements for redundancy.
Arai Pump from BTGC
Arai Pump Mfg. Co., Ltd. of Japan makes screw pumps and rotary plunger pumps used in lube oil systems, fuel injection and viscous fluid transfer. BTGC is the Arai Pump partner in Saudi Arabia. See also positive displacement pumps, slide bearings and the rotating equipment page.
Questions buyers ask
Why does a compressor trip on low oil pressure when the standby pump is fine? The standby may start too slowly or the pressure switch may be set too close; test the changeover.
How often should console filters be changed? When differential pressure reaches the set limit, or at the maker's interval.
Can BTGC supply replacement console pumps? Yes, Arai pumps for new consoles and replacements.
Contact BTGC
Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.