Slide Bearings for Large Motors and Generators: Lubrication, Monitoring and Failures

17.11.26 11:58 AM

In short: large motors, generators, compressors and gear units often run on hydrodynamic slide (sleeve) bearings instead of rolling bearings. The shaft floats on a thin oil film formed by rotation, so a healthy slide bearing has almost no wear and a very long life. Problems come when the oil film is lost or damaged: low oil, contaminated oil, a stuck oil ring, misalignment or electrical currents through the bearing. Correct lubrication, temperature and vibration monitoring and good alignment keep them reliable. BTGC supplies RENK slide bearings.

RENK gear units, bearings and couplings

High voltage motors on pumps and compressors, generators in power plants and large fans in Saudi plants commonly use flange or pedestal slide bearings. A bearing wipe can damage the shaft and stator and take a machine out of service for weeks.

Lubrication methods

MethodHow it worksTypical use
Self-lubricating with oil ringA loose ring on the shaft lifts oil from the sump to the bearingModerate speeds and loads
Self-lubricating with water or air coolerOil ring lubrication with extra cooling in the housingHigher heat loads
Flood (forced) lubricationOil supplied from an external system with cooling and filteringHigh speeds, high loads, large machines

Monitoring

  • Bearing metal temperature with RTDs or thermocouples, with alarm and trip points set from the maker's data.

  • Shaft vibration with proximity probes on critical machines, or housing vibration on smaller ones.

  • Oil level, oil temperature and, for flood lubrication, oil pressure and flow.

  • Oil condition: water, particles, oxidation and varnish; see turbine oil varnish prevention.

Large high voltage motor

Common failure causes

  • Loss of oil film from low level, a sticking oil ring or blocked supply.

  • Contaminated oil with dust, water or wear particles.

  • Misalignment that overloads one end of the bearing.

  • Electrical pitting from shaft currents, especially on VFD-fed motors; insulated bearings and grounding help, see VFD bearing currents.

  • Wrong clearance after repair or re-babbitting.

RENK from BTGC

RENK of Germany makes high-performance gear units, slide bearings and couplings for industrial, energy and marine drives, including E-type bearings used on electric motors and generators. BTGC is the RENK partner in Saudi Arabia, with full electric motor services at the Jubail service center. See also motor vibration analysis, synchronous motors and the rotating equipment page.

Questions buyers ask

Can a wiped slide bearing be repaired? Often yes, by re-babbitting and machining to the correct clearance, if the shaft journal is in good condition.

Why is one bearing on a motor insulated? To break the path for shaft currents that would otherwise pit the bearing surfaces.

Does BTGC supply complete bearing assemblies? Yes, RENK bearing housings, shells, seals and oil rings.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.