Positive Displacement Pumps for Viscous Fluids: Screw, Gear and Plunger Pumps

17.11.26 11:52 AM

In short: centrifugal pumps lose efficiency quickly as viscosity rises, so heavy oils, polymers, resins, asphalt and lube oils are usually better handled by positive displacement (PD) pumps. PD pumps deliver a nearly fixed volume per revolution, so flow follows speed and hardly changes with pressure. Screw and gear pumps give smooth flow for transfer and lube systems; plunger pumps give high pressure and accurate metering. Because a PD pump will keep building pressure against a closed valve, relief protection is essential. BTGC supplies Arai rotary plunger and screw pumps.

Process piping in a petrochemical plant

Lube oil and seal oil consoles on compressors and turbines, fuel oil systems, polymer and additive transfer, and heavy oil loading in Saudi plants all depend on positive displacement pumps.

Centrifugal or positive displacement?

  • As viscosity increases, centrifugal pump head, flow and efficiency all fall; correction methods show large losses at high viscosity.

  • PD pumps keep good efficiency with viscous fluids and give steady flow regardless of system pressure.

  • PD pumps handle entrained gas and self-prime better in many designs.

  • Centrifugal pumps remain simpler for large flows of thin liquids.

Common PD pump types

TypeStrengthsTypical uses
Screw pumpsSmooth, low-pulsation flow, quiet, wide viscosity rangeLube oil systems, fuel oil, crude and heavy oil transfer
Gear pumpsCompact and economicalAdditives, lube oil, polymers
Plunger and piston pumpsHigh pressure and accurate meteringChemical injection, high-pressure feed
Rotary plunger pumpsHigh-viscosity and shear-sensitive fluidsPolymer and resin transfer
Oil and gas processing facility

Design and safety points

  • Always provide pressure relief: an internal or external relief valve or a system relief, because a PD pump can over-pressure a closed line.

  • Check suction conditions carefully; viscous fluids need generous suction lines and enough NPIP.

  • Use heat tracing or jackets where the fluid thickens when cool.

  • Dampen pulsation on reciprocating pumps to protect piping and instruments; see gauges under pulsation.

  • Choose shaft seals suited to the fluid and temperature.

  • Use API 676 for rotary and API 674 for reciprocating pumps where specified.

Arai Pump from BTGC

Arai Pump Mfg. Co., Ltd. of Japan makes rotary plunger pumps and screw pumps for viscous, high-temperature and difficult fluids. BTGC is the Arai Pump partner in Saudi Arabia. See also API 610 centrifugal pump types and the rotating equipment page.

Questions buyers ask

At what viscosity should I consider a PD pump? There is no single limit, but once viscosity reaches a few hundred centistokes, a PD pump is often more efficient. A selection check with real data is best.

Can flow be adjusted on a PD pump? Yes, mainly by changing speed with a variable speed drive.

Does BTGC supply spare parts for Arai pumps? Yes, genuine spare parts and service kits.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.