Strip Tension Measurement in Cold Rolling and Process Lines

16.11.26 09:05 AM

In short: strip tension controls thickness and flatness in cold rolling and keeps the strip tracking straight through pickling, annealing and coating lines. If it is measured wrongly, the mill makes off-gauge coils or breaks strip. Kelk TENSIOMETER rolls measure tension directly under the strip, and BTGC supplies and supports them for Saudi steel and aluminium mills.

Kelk rolling mill sensors range

In a cold mill, tension between the stands and at the coilers does part of the work the rolls do: higher tension reduces the roll force needed for the same reduction. That makes tension one of the main control variables for gauge and shape. On processing lines, tension keeps the strip flat and centred through furnaces and tanks. In both cases the drive torque alone is not a reliable measure, because friction, inertia and roll wear change it.

How a tensiometer measures tension

The strip wraps a deflector roll at a known angle. The tension in the strip produces a resultant force on the roll, and load cells under the roll bearings measure that force. From the wrap angle the system calculates tension directly. Good designs cancel the weight of the roll and are insensitive to strip position across the roll face.

WhereWhy tension is measured
Between stands of a cold tandem millGauge control and stand balance
Coilers and uncoilersCoil build quality, no telescoping
Pickling, annealing and coating linesStrip flatness, tracking and break prevention
Aluminium foil and can-stock millsThin gauges where small tension changes cause breaks
Kelk laser velocimeter for rolling mills

Signs the tension measurement needs attention

  • Gauge or flatness problems that the control system cannot correct.

  • Strip breaks at coil changes or speed changes.

  • Drift between the measured tension and the drive calculation.

  • Load cells that have not been checked since the mill was commissioned.

Kelk from BTGC

Kelk, part of Vishay Precision Group, builds TENSIOMETER strip tension systems, ROLLMAX roll force systems, laser velocimeters and width gauges for rolling mills. BTGC is the Kelk partner in Saudi Arabia. See also roll force load cells, laser velocimeters and the metals and steel sector page.

Questions buyers ask

Can tensiometer rolls be retrofitted on an existing line? Usually yes, either by replacing an existing deflector roll or by fitting load cells under its bearings; BTGC coordinates the survey with Kelk.

How often should tension systems be calibrated? At major shutdowns, with a known weight or calibration load over the roll.

Do you supply spare load cells? Yes; spares for critical positions are recommended.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.