Turbine Generator Inspection: Stator, Rotor and Insulation Testing

18.11.26 08:23 AM

In short: turbine generators in power plants run for years between major outages, so each inspection must find developing problems before they cause a forced outage. Inspections look at stator windings, wedges and end windings, rotor windings and retaining rings, bearings, seals and cooling systems, backed by electrical tests such as insulation resistance, polarisation index, tan delta and partial discharge. Trending results over several outages shows where the machine is heading. BTGC supports Fuji Electric turbine generators.

Power plant steam piping

Power, cogeneration and desalination plants in the Kingdom rely on large air- and hydrogen-cooled generators. Summer peaks leave little room for unplanned outages.

Main inspection areas

AreaWhat to look for
Stator windingsContamination, insulation damage, loose blocking, signs of discharge
Stator wedgesLooseness that allows bar vibration
CoreHot spots, damaged laminations
Rotor windingsShorted turns, earth faults, contamination
Retaining rings and rotor bodyCracks and corrosion, checked by NDE
Bearings, seals and coolersWear, leaks and fouling

Common electrical tests

  • Insulation resistance and polarisation index for overall insulation condition.

  • Tan delta or power factor tests for insulation ageing.

  • Partial discharge measurements, online or offline, for developing defects.

  • Winding resistance to detect connection problems.

  • Rotor tests for shorted turns, such as pole drop or flux probe checks.

Stator winding inspection

Planning outages

  • Use online monitoring and earlier results to set the inspection scope.

  • Plan rotor removal where needed, or use in-situ inspection tools for shorter outages.

  • Prepare spare parts such as wedges, seals and bearing parts.

  • Coordinate with turbine work; see steam turbine overhaul planning.

  • Record results to compare at the next outage.

Fuji Electric from BTGC

Fuji Electric's power generation business covers thermal and geothermal power plants with steam turbines and generators. BTGC is the Fuji Electric partner in Saudi Arabia for power generation equipment: enquiries, spare parts and after-sales service. See also steam turbine condition monitoring, slide bearings and the power and utilities sector page.

Questions buyers ask

How often should a generator be inspected? Minor inspections are common every few years and major ones at longer intervals, per OEM and plant history.

What does partial discharge testing show? Small electrical discharges that indicate developing insulation defects.

Does BTGC support Fuji Electric generators? Yes, with spare parts and after-sales service coordination.

Contact the BTGC power division

Email power@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.