Air-Cooled Condenser Fan Drives: Gear Units for Power Plants

18.11.26 01:11 PM

In short: air-cooled condensers (ACCs) condense turbine exhaust steam with large fans instead of cooling water, which suits power plants in a water-scarce country. Each fan is driven through a gear unit that must carry the fan's thrust and weight, run quietly and keep its oil cool in desert summers. Gear unit failures cut condenser capacity and turbine output when power is most needed. BTGC supplies Hansen gear units for ACC and cooling fans.

Air-cooled heat exchanger fan units

Many power and cogeneration plants in the Kingdom use ACCs with dozens of fans on a high deck.

The duty of an ACC fan drive

RequirementWhy it matters
Fan thrust and weightThe output bearings carry fan thrust, which changes with blade pitch and wind
Low noiseLarge fan banks often sit near site boundaries
Variable speedFans run on VFDs to follow load and ambient
Long running hoursFans run most of the year and hardest in summer
Compact, sealed designUnits sit high under the fans with limited access

Keeping fan drives reliable

  • Use oil grades and coolers suited to high ambient, and check oil temperature in summer.

  • Keep breathers and seals in good order, since dust and leaks shorten life.

  • Monitor vibration; see gear unit condition monitoring.

  • Check fan balance and blade pitch, because imbalance loads the gear unit.

  • Avoid running for long at VFD speeds that excite resonance.

Gears and bearings inside an industrial gear unit

Replacement planning

  • Hold at least one spare gear unit for a large ACC so a failed unit can be swapped quickly.

  • Check that replacement units match the mounting, shafts and fan interface.

  • Plan crane access for gear unit changes on the ACC deck.

  • Compare with wet cooling tower drives; see cooling tower gearboxes.

Hansen from BTGC

Hansen Industrial Transmissions, part of Sumitomo Drive Technologies, makes P4 industrial gear units and M4 application units, including air-cooled condenser fan drives. BTGC supplies Hansen in Saudi Arabia with spare parts. See also thermal management and cooling and the power and utilities sector page.

Questions buyers ask

Why do ACC gear units fail? Common causes are hot or dirty oil, fan imbalance and bearing overload from thrust.

Can these units run on VFDs? Yes, when rated for the speed range; check lubrication at low speed.

Does BTGC supply spare parts? Yes, bearings, seals and gear sets for installed Hansen units.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.