Gear Unit Condition Monitoring: Oil Analysis, Vibration and Thermography

17.11.26 04:30 PM

In short: industrial gear units usually give warning before they fail: wear particles appear in the oil, vibration patterns change and temperatures rise. A simple condition monitoring routine combining oil analysis, vibration and thermography catches most problems early enough to plan a repair instead of suffering a breakdown. The key is regular measurement, consistent methods and acting on the trends. BTGC supplies Hansen industrial gear units and supports their upkeep.

Industrial gears and bearings

Conveyors, mills, cooling towers, mixers and crushers in the Kingdom rely on gear units that often run in heat and dust. Breakdowns are expensive because large gear units have long lead times.

What each method catches

MethodDetects
Oil analysisWear metals, contamination, water, oil degradation
Vibration analysisGear mesh problems, bearing defects, misalignment, looseness
ThermographyOverheating bearings, lubrication problems, overload
Visual and acoustic checksLeaks, noise changes, loose fasteners
Borescope inspectionTooth surface damage without dismantling

Setting up a routine

  • List gear units by criticality and set intervals accordingly.

  • Take oil samples from the same point, at operating temperature, in clean bottles.

  • Measure vibration at fixed points and directions with consistent settings.

  • Use thermography during normal load, comparing similar units.

  • Store results in one place and review trends, not single readings.

Industrial plant

Acting on results

  • Rising iron or particle counts: check for wear and filter or change oil; see gear oil.

  • Water in oil: find the source, such as breathers or seals.

  • New vibration frequencies: investigate gears, bearings and alignment.

  • Hot bearings: check lubrication, load and alignment.

  • Plan repairs and spares when trends show deterioration.

Hansen from BTGC

Hansen Industrial Transmissions of Belgium, part of the Sumitomo Drive Technologies group, makes industrial gear units for conveyors, mills, mixers and cooling towers. BTGC is the Hansen partner in Saudi Arabia. See also cooling tower gearboxes, conveyor gear units and the rotating equipment page.

Questions buyers ask

How often should gearbox oil be sampled? Critical units often monthly or quarterly; less critical units less often.

Is vibration analysis enough on its own? It catches many faults, but oil analysis often detects wear earlier.

Can BTGC help set up monitoring? Yes, with recommendations for Hansen and other gear units.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.