Compressed Air Piping Design: Sizing, Materials and Pressure Drop

18.11.26 08:18 AM

In short: compressors are often blamed for low pressure at machines, when the real culprit is the piping. Undersized pipes, long branches, sharp bends and leaking fittings waste pressure, so the compressor is set higher and uses more energy. A well-designed system uses a loop main sized for low pressure drop, takes branches from the top of headers, drains water at low points and uses materials that do not corrode. BTGC supplies Ingersoll Rand compressors, dryers and air system equipment.

Ingersoll Rand compressor

Factories, workshops, plants and warehouses in the Kingdom often grow their air systems piece by piece, leaving bottlenecks and leaks behind.

Design principles

PrincipleWhy it matters
Loop or ring mainAir reaches each user from two directions, lowering pressure drop
Generous pipe sizesLow velocity and low pressure drop; future growth
Branches from the topKeeps water in the header away from tools
Slope and drainsWater collects at low points where it can be removed
Receivers near big usersBuffer sudden demands without raising system pressure

Choosing materials

  • Aluminium modular systems: light, smooth, quick to install and modify.

  • Stainless steel: corrosion resistant for demanding areas.

  • Galvanised steel: common but can corrode and shed scale over time.

  • Avoid plastics not rated for compressed air.

  • Use sealed fittings to reduce leaks; see compressed air energy savings.

Plant piping

Checking an existing system

  • Measure pressure at the compressor and at the far end under load.

  • Look for long small-bore branches and restrictive quick couplings.

  • Survey and repair leaks regularly.

  • Make sure dryers and filters are not undersized; see air quality and dryers.

  • Protect outdoor piping from sun and heat where possible.

Ingersoll Rand from BTGC

Ingersoll Rand makes compressed air and gas equipment, including centrifugal and oil-free compressors, dryers and blowers. BTGC is the Ingersoll Rand partner in Saudi Arabia. See also compressor rooms in hot climates and the rotating equipment page.

Questions buyers ask

What pressure drop is acceptable in an air system? Many designers aim for a small fraction of a bar between compressor and point of use.

Why take branches from the top of the header? Water runs along the bottom of pipes, so top connections keep it away from tools.

Can BTGC help improve an air system? Yes, with Ingersoll Rand equipment and application support.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.