Cooling Electrical Panels and Drive Enclosures in Saudi Heat

17.11.26 11:59 AM

In short: electronics fail early when they run hot. Drives, PLCs, power supplies and protection relays inside closed panels add their own heat to the hot air around them, and in Saudi summers the outside air is often hotter than the electronics can tolerate. Filter fans and air-to-air heat exchangers only work when the outside air is cooler than the required panel temperature; otherwise a refrigerant cooling unit or an air-to-water heat exchanger is needed. Correct sizing, sealing and condensate handling are the keys. BTGC supplies Pfannenberg enclosure cooling, chillers and signalling products.

Pfannenberg enclosure cooling units

Outdoor kiosks, motor control centres, VFD panels in pump stations and control panels on skids are common in Saudi plants. Many electronics are rated for about 40 to 50 degC, while panels in the sun can easily exceed that without active cooling.

Choosing the cooling method

MethodWorks whenNotes
Filter fanOutside air is well below the required panel temperatureCheapest; brings in dust, so filters need cleaning
Air-to-air heat exchangerOutside air is below the panel temperatureKeeps the panel sealed from dust
Cooling unit (panel air conditioner)Outside air is hotter than the required panel temperatureUsual choice for Saudi summers; needs condensate management
Air-to-water heat exchangerChilled or cooling water is availableHigh capacity, sealed panel

Sizing the heat load

  • Add the heat losses of all equipment; drives typically lose a few percent of their rated power as heat.

  • Add heat entering through the panel walls from hot air and direct sun.

  • Choose the maximum allowed inside temperature from the equipment data, often around 35 degC.

  • Size for the hottest expected ambient, not the yearly average.

  • Shade outdoor panels where possible to cut solar gain.

AC drives inside an electrical panel

Installation and maintenance

  • Keep the panel sealed to its IP rating; open cable entries let in hot, dusty air. See IP ratings.

  • Arrange airflow so cold air reaches equipment and does not short-circuit back to the unit.

  • Fit door switches so cooling units stop when the door is open, reducing condensation.

  • Lead condensate safely away from electrical equipment.

  • Clean condenser coils and filters regularly; dust is the main cause of cooling unit trips.

Pfannenberg from BTGC

Pfannenberg of Germany makes filter fans, cooling units, heat exchangers and process chillers for electrical enclosures, and signalling devices. BTGC is the Pfannenberg partner in Saudi Arabia. See also VFDs for pumps and fans, batteries in Saudi heat and the electrical power systems page.

Questions buyers ask

Why does my drive panel trip on high temperature only in summer? The outside air is too hot for fans to cool the panel; a cooling unit is usually needed.

Can a cooling unit be fitted to an existing panel? Yes, on the side wall, door or roof, after checking the heat load and panel structure.

Does BTGC help with heat load calculations? Yes, from the equipment list, panel size and site conditions.

Contact the BTGC power division

Email power@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.