Gear Tooth Damage: Recognising Pitting, Scuffing, Wear and Breakage

18.11.26 08:21 AM

In short: when an inspection cover comes off a gear unit, the tooth surfaces tell the story of how the gears have been running. Polished or worn teeth, grey micropitting, larger pits, scuffing marks, rolled edges and cracked or broken teeth each point to different causes, from dirty oil to overload or misalignment. Recognising them early lets maintenance teams fix the cause and plan repairs before a tooth breaks. BTGC supplies SEISA gear units, gears and spare parts.

Industrial gears

Steel, cement, mining and process plants in the Kingdom inspect gear units at shutdowns. Recording what the teeth look like, with photos, builds a history that guides decisions.

Common damage types

DamageAppearanceTypical causes
WearPolished or thinned teeth, steps at the end of contactAbrasive particles, low film thickness
MicropittingGrey, matte areasThin oil film, surface roughness, oil choice
MacropittingDistinct pits that growSurface fatigue from high contact stress
ScuffingScored, torn bands along the profileOil film breakdown, high speed and load
Plastic deformationRolled or rippled edgesVery high loads on softer gears
Tooth breakageCracks at the root or missing teethBending fatigue, overload, shock

What to do when you find damage

  • Photograph and record the location and extent on each gear.

  • Check the contact pattern for misalignment.

  • Take an oil sample and check for particles and water.

  • Review loads, shocks and recent process changes.

  • Decide whether to run and monitor, repair or replace; see gear unit refurbishment.

Heavy industrial drive

Preventing damage

  • Keep oil clean and within the right viscosity and temperature; see gear unit lubrication.

  • Check alignment after installation and repairs.

  • Avoid sustained overloads and repeated shocks.

  • Monitor vibration and oil condition between inspections.

  • Inspect at fixed intervals and compare with earlier photos.

SEISA from BTGC

SEISA Gear, Ltd. of Japan makes gear units, high-speed gears, epicyclic gears and gear couplings. BTGC is the SEISA partner in Saudi Arabia. See also epicyclic gear units, gear couplings and the metal sector page.

Questions buyers ask

Is micropitting dangerous? It can progress to larger pits and tooth damage, so it should be monitored and its cause addressed.

What causes scuffing? Breakdown of the oil film under high load and sliding speed.

Does BTGC supply replacement gears? Yes, SEISA gears and complete gear units.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.