Valves for Sewer and Wastewater Networks: Clog-Free Designs and H2S Corrosion

17.11.26 12:39 PM

In short: sewage contains rags, fats, grit and solids that clog valves designed for clean water, and it releases hydrogen sulphide that corrodes metal and concrete. Valves for sewer rising mains, pumping stations and treatment plants therefore need full-bore, clog-resistant designs, check valves that close without slamming, special sewage air valves, and coatings that resist corrosion. BTGC supplies AVK and AVK SVMC valves for water and wastewater.

AVK valves made in Saudi Arabia

The Kingdom is extending sewer networks and building new treatment plants to support growing cities and water reuse targets. Valve failures in sewer systems cause overflows, pump damage and costly emergency repairs.

Valve types for wastewater

ValveRoleNotes
Resilient-seated gate valveIsolation on rising mains and in pumping stationsFull bore with no seat pocket where solids collect
Knife gate valveIsolation on sludge and solids linesCuts through solids; see knife gate valves
Swing or ball check valvePrevents backflow at pump dischargesChoose designs that close smoothly to limit surge
Sewage air valveReleases air and gas at high pointsSpecial body and float design that resists fouling by grease and solids
Penstocks and sluice gatesChannel and tank isolationCorrosion-resistant materials

Corrosion and protection

  • Use ductile iron bodies with thick fusion-bonded epoxy coating inside and out.

  • Choose stainless steel stems, bolts and fasteners.

  • Ventilate wet wells and valve chambers to reduce H2S build-up.

  • Protect buried valves with suitable external coatings and wrapping.

Water and wastewater pipeline

Operation and maintenance

  • Exercise isolation valves regularly so they work in an emergency.

  • Clean and service sewage air valves on a schedule; a blocked air valve can cause pipe bursts.

  • Check check valves for slamming and wear, and fit dampers or change type if surge is a problem.

  • Record valve locations, sizes and conditions in the network GIS.

  • Use safe entry procedures for chambers with H2S.

AVK from BTGC

AVK of Denmark makes valves, hydrants and fittings for water, wastewater and gas; AVK SVMC manufactures in the Kingdom. BTGC is the AVK partner in Saudi Arabia. See also water network valves and hydrants, wastewater lift station pumps and the power and utilities sector page.

Questions buyers ask

Can a clean water air valve be used on a sewer main? No. Sewage air valves are designed so grease and solids do not foul the float and seal.

Why do check valves slam? They close after flow has reversed; designs with faster or damped closing reduce slam and surge.

Does BTGC supply locally made wastewater valves? Yes, through AVK SVMC in the Kingdom.

Contact the BTGC valve team

Email valves@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.