Split Case Pumps for Water Transmission and Cooling Water: Selection and Care

17.11.26 09:42 AM

In short: the axially split case pump, with a double-suction impeller between two bearings, is the workhorse for large clean-water duties: water transmission, cooling water, district cooling and fire water. It runs efficiently, has low suction requirements and balanced axial thrust, and the top half of the casing lifts off for maintenance without disturbing the piping. Long life depends on selecting it close to its best efficiency point, giving it a good suction pipe and keeping clearances and alignment in check. BTGC supplies Pentair Aurora and Fairbanks Nijhuis split case pumps.

Pentair Aurora vertical split case pump

Water transmission systems, district cooling plants serving new developments, and cooling water systems at power and industrial plants in the Kingdom run their pumps for most of the year. Energy is the largest part of a pump's life-cycle cost, so efficiency and correct operating point matter as much as the purchase price.

Why split case

  • The double-suction impeller takes water from both sides, which balances axial thrust and lowers the NPSH the pump needs.

  • High efficiency at large flows.

  • Horizontal versions allow inspection of the rotor by lifting the top half casing; vertical versions save floor space.

  • Bearings at both ends of the shaft give a stiff rotor and long bearing life.

Selecting the pump

  • Choose a pump whose rated point is close to its best efficiency point, and check that minimum and maximum operating points stay inside the preferred operating region, often about 70 to 120 per cent of best efficiency flow.

  • Check NPSH available against NPSH required with a margin, especially with warm water and long suction lines.

  • Where flow varies widely, consider variable speed drives instead of throttling; see VFDs and bearing currents.

  • For parallel pumps, select curves that share load evenly.

Common problemLikely cause
Noise and vibration at low flowOperation far left of best efficiency point, recirculation
Cavitation damage on the impeller eyeLow NPSH margin, poor suction pipe layout
Uneven wear on the two impeller sidesElbow close to the suction in the plane of the shaft
Falling flow and efficiencyWorn wear rings, increased internal leakage
Bearing failuresMisalignment, pipe strain, poor lubrication
Large water transmission pipeline

Installation and maintenance

  • Give the suction a straight run of several pipe diameters and avoid an elbow in the plane of the shaft directly before the inlet, which feeds the two impeller eyes unevenly.

  • Support piping independently so it does not load the casing, and check alignment after the piping is connected.

  • Track wear ring clearances; restoring them restores efficiency.

  • Maintain mechanical seals or packing as the manufacturer specifies, and keep seal flush clean.

  • Trend vibration, bearing temperature and motor current to catch problems early.

Pentair split case pumps from BTGC

BTGC is the Pentair partner in Saudi Arabia for split case pumps and spare parts, with WEG motors and Danfoss VACON drives. See also cooling tower performance and the pumps and rotating equipment page.

Questions buyers ask

Can a split case pump run with a variable speed drive? Yes, as long as the minimum speed keeps the pump inside its operating region and the system curve suits it.

How often should wear rings be replaced? When clearance has grown to about double the new value or efficiency has fallen noticeably; trend performance to decide.

Can BTGC match an existing pump? Yes. Send the nameplate, curve and installation dimensions.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.