Boiler Feedwater and Spray Water Control Valves in Power and Desalination Plants

17.11.26 03:09 PM

In short: in steam power, cogeneration and thermal desalination plants, a few control valves decide how well the boiler and steam system behave: feedwater regulating valves, start-up and low-load feedwater valves, pump recirculation valves and desuperheater spray water valves. They take high pressure drops, see temperature swings and must control smoothly from start-up to full load. Wrong sizing or trims lead to cavitation, erosion, leakage and poor drum or temperature control. BTGC supplies KOSO severe service control valves.

KOSO severe service control valves

Power and water plants in the Kingdom cycle more often as demand changes through the day and season, which puts extra strain on feedwater and spray valves that were designed for steady base load.

Key valves and their challenges

ValveMain challenge
Main feedwater controlAccurate level control across a wide load range
Start-up and low-load feedwaterVery high pressure drop at low flow, cavitation risk
Boiler feed pump recirculationFull pump pressure dropped to deaerator pressure; severe cavitation duty
Desuperheater spray waterHigh pressure drop, tight shutoff to avoid spray leakage into hot steam lines

Design solutions

  • Multi-stage anti-cavitation trims for recirculation and low-load valves; see cavitation and noise.

  • Split ranging between a small start-up valve and a large main valve to cover the full load range.

  • Hardened trims and tight shutoff classes to stop leakage that erodes seats and damages steam lines.

  • Positioners with diagnostics to track friction and seat condition.

  • Check every operating case, including start-up, minimum load and pump trips.

Power plant steam line valves

Maintenance tips

  • Watch for leakage on spray valves: water dripping into hot steam lines causes thermal fatigue cracking.

  • Inspect recirculation valve trims at every major outage.

  • Trend valve position against load to detect trim wear.

  • Check positioner calibration and actuator air supply.

  • Keep spare trims for the most severe valves.

KOSO from BTGC

Nihon KOSO makes severe service control valves, actuators and positioners for power, oil and gas and process plants. BTGC is the KOSO partner in Saudi Arabia, with valve testing and repair at the Jubail service center. See also feedwater check valves, anti-surge valves and the power and utilities sector page.

Questions buyers ask

Why do recirculation valves fail so quickly? They drop the full pump pressure in one valve; without a multi-stage trim, cavitation erodes them fast.

Why does spray valve leakage matter? Water leaking into hot steam lines causes thermal shock and cracking.

Can BTGC upgrade existing feedwater valves? Often yes, with new trims or replacement valves sized for the real operating range.

Contact the BTGC valve team

Email valves@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.