Crusher Hammer Tips: Longer Hammer Life with Bimetallic Tips

18.11.26 03:06 PM

In short: crusher hammers wear fastest at the tip, where they strike the material. Instead of replacing the whole hammer, a bimetallic tip with a hard white iron face can be welded onto the hammer's steel body, putting the hardest material where the wear happens. Hammers last longer, and worn hammers can be rebuilt instead of scrapped. Balancing and fitting procedures matter as much as the tip itself. BTGC supplies Bimat bimetallic hammer tips.

Crushers and feeders

Hammermills and impact crushers in cement, gypsum, limestone, coal and phosphate service in the Kingdom go through hammers quickly.

Hammer protection options

OptionStrengthsLimits
Manganese steel hammersTough, work-harden under impactWear fast in abrasive, low-impact duty
Hardfaced hammersRebuildable, flexibleThin layer; welding time and skill
Bimetallic tipsThick, very hard wear face on a weldable backingMust suit the impact level of the crusher

Fitting tips correctly

  • Weld only through the steel backing with the supplier's procedure and consumables.

  • Never weld on the white iron face or quench the tip.

  • Prepare the hammer surface to sound metal before fitting.

  • Fit tips on hammers in matched sets so rotor balance is kept.

Crushing plant at a Saudi mine

Balance and tracking

  • Weigh hammers and arrange them in balanced sets around the rotor.

  • Rotate or reverse hammers where the design allows, to use both faces.

  • Track tonnage per hammer set to compare options; see wear measurement.

  • Check rotor balance and bearings after hammer changes; see rotor and bearing care.

Bimat from BTGC

Bimat supplies bimetallic hammer tips, chocky bars, wear bars, buttons and plates. BTGC supplies Bimat in Saudi Arabia. See also crusher wear parts, hardfacing or bimetallic and the mining and minerals sector page.

Questions buyers ask

Are bimetallic tips suitable for every crusher? They suit abrasive duties best; very high impact duties need care in design and fitting.

Can worn hammers be retipped? Often yes, if the hammer body is sound.

How do I keep the rotor balanced? Weigh hammers and fit them in matched sets.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.