Measuring Wear: Thickness Checks and Replacement Planning for Wear Parts

18.11.26 08:10 AM

In short: wear parts are replaced either too early, wasting good material, or too late, after a hole in a chute or a lost tooth damages equipment and stops production. Measuring wear regularly, with thickness gauges, templates or scanning, and converting it into wear rates per tonne handled lets maintenance teams predict the right replacement date and compare materials objectively. BTGC supplies Bimat bimetallic wear parts for mining, cement, ports and bulk handling.

Mining equipment with wear parts

Mines, cement plants, steel plants and bulk terminals in the Kingdom spend heavily on liners, buckets, chutes, hoppers and teeth. Good wear data cuts both cost and downtime.

Measurement methods

MethodTypical use
Ultrasonic thickness gaugePlates, liners and chute walls from one side
Templates and gaugesBucket teeth, lips and edges
Wear indicatorsHoles or marks that show when a set depth is reached
3D laser scanningMill liners, large chutes and hoppers
Photos at fixed pointsVisual trend between inspections

From measurements to plans

  • Measure at the same points each time and record tonnage since installation.

  • Calculate wear rate, such as mm per 100,000 tonnes.

  • Set a minimum thickness and forecast when it will be reached.

  • Group replacements into planned stops where possible.

  • Use the data to compare materials and designs; see bimetallic wear parts.

Bulk handling equipment

Practical tips

  • Clean surfaces before measuring for reliable readings.

  • Mark measurement points on drawings and on the equipment.

  • Note impact damage separately from sliding wear.

  • Store results in the maintenance system, not in personal notebooks.

  • Hold spares for parts with short or uncertain lives.

Bimat from BTGC

Bimat of Germany supplies bimetallic wear parts for mining, earthmoving, cement, ports and bulk handling equipment. BTGC is the Bimat partner in Saudi Arabia. See also cement plant wear protection, port hoppers and grabs and the mining and metals sector page.

Questions buyers ask

How often should wear be measured? It depends on wear rate; fast-wearing parts may need weekly checks, others at each shutdown.

Why measure wear per tonne? It allows fair comparison between materials and forecasting by production plan.

Does BTGC supply replacement wear parts? Yes, Bimat bimetallic wear parts.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.