Replacing an Old Gear Unit: Interchangeability and Upgrades

18.11.26 02:58 PM

In short: many plants run gear units that are decades old, sometimes from makers that no longer exist. When one fails, the fastest fix is a replacement that bolts into the same place: same shaft heights, centre distances, shaft sizes, ratio and rotation. Modern units often give more capacity in the same space, so a replacement can also fix a unit that was undersized. BTGC supplies Hansen industrial gear units and spares.

Gears and bearings inside a gear unit

Conveyors, mixers, cooling towers and mills across Saudi plants still run on original gear units from the 1980s and 1990s.

What must match

ItemWhy it matters
Mounting footprint and bolt holesAvoid new foundations or base frames
Shaft heights and positionsKeep existing couplings and alignment
Shaft diameters, keys and rotationFit existing couplings and drive direction
Ratio and speedKeep the process speed unchanged
Rated torque and thermal capacityMust meet or exceed the real duty
AccessoriesBackstop, fan, cooler, heater and instruments

Collecting the data

  • Record the nameplate, then measure the unit and its connections if drawings are missing.

  • Note the driven machine, motor power, speed, starts per hour and ambient.

  • Check the condition of foundations and couplings, which may also need work.

  • Photograph the installation from all sides.

Conveyor drives at a mining plant

Planning the swap

  • Order the replacement before the old unit fails completely, if signs allow; see condition monitoring.

  • Use an adapter plate when an exact footprint match is not possible.

  • Fit new couplings with the new unit where the old ones are worn.

  • Commission with clean oil and correct alignment; see gear unit lubrication systems.

Hansen from BTGC

Hansen Industrial Transmissions, part of Sumitomo Drive Technologies, makes P4 industrial gear units and M4 application units. BTGC supplies Hansen in Saudi Arabia for replacements and spares. See also repair or replace, asset re-engineering and the mining and material handling page.

Questions buyers ask

Can a different brand replace my old gear unit? Often yes, if dimensions, ratio and rating match; an adapter plate can handle small differences.

What data does BTGC need? Nameplate, photos, motor data and the driven machine's duty.

Is repair cheaper than replacement? Sometimes, but long repair times and old designs can make replacement better value.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.