Isolation Valves for Hot Gas, Flue Gas and Exhaust Lines

17.11.26 12:35 PM

In short: lines carrying hot gas, such as furnace and reformer effluent, flue gas, turbine exhaust and hot air, need isolation valves that stay tight and operable at temperatures where ordinary valves warp, seize or leak. Large triple-offset butterfly valves, refractory-lined valves and special fabricated designs are used depending on temperature, pressure, size and how tight the shutoff must be. Materials, thermal expansion and actuation all need careful attention. BTGC supplies Krombach high-temperature and large-diameter valves.

Krombach-Armaturen valve range

Steam crackers, reformers, direct reduction and steel plants, sulphur recovery units and power plants with heat recovery steam generators in the Kingdom all have large hot gas lines. A stuck or leaking valve there can stop a unit or create a safety hazard.

Valve options by duty

DutyCommon choice
Hot process gas up to several hundred degC, tight shutoffMetal-seated triple-offset butterfly valves or gate valves in high-temperature alloys
Very hot gas above about 800 degCRefractory-lined or internally insulated valves, sometimes with cooling
Flue gas and exhaust isolation, low pressureFabricated isolation valves or dampers with seal air systems
Diverter serviceValves or diverters that switch flow between paths, for example bypass and heat recovery

Selection points

  • Temperature, pressure, gas composition and any dust, soot or condensing acids.

  • Required leakage rate: tight isolation for maintenance, or control and diversion only.

  • Materials: heat-resistant steels and alloys chosen for creep strength and oxidation resistance; see valve body materials.

  • Thermal expansion of the valve and connected ducts; the valve must not bind as it heats.

  • Actuator sizing for torque at high temperature, and actuator protection from radiant heat.

Petrochemical plant with furnaces

Operation and maintenance

  • Warm up and cool down lines and valves gradually where possible.

  • Check seat tightness and stem packing at each turnaround.

  • Inspect refractory linings for cracks and repair them before they spread.

  • Keep actuators, positioners and limit switches shielded and cooled.

  • Record stroke times and operating torque to detect binding early.

Krombach from BTGC

Krombach-Armaturen of Germany builds triple-offset butterfly valves, fabricated gate and check valves, bottom drain valves and valves for extreme temperatures above 800 degC. BTGC is the Krombach partner in Saudi Arabia. See also butterfly valve types, bottom outlet valves and the petrochemicals sector page.

Questions buyers ask

Why do standard valves seize in hot gas lines? Uneven thermal expansion and oxidation at high temperature bind the moving parts.

Is a triple-offset butterfly valve suitable for very high temperature? Up to its material limits; above that, refractory-lined or special designs are used.

Can BTGC supply large-diameter custom valves? Yes, Krombach fabricates large valves to project specifications.

Contact the BTGC valve team

Email valves@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.