In short: critical compressor, pump, gear and turbine trains are protected by systems that watch shaft vibration, axial position and bearing temperatures continuously and trip the machine before damage occurs. API 670 sets out how these systems should be specified and installed. Good protection catches real faults quickly, while correct probe installation, sensible set points and voting logic avoid costly false trips. BTGC supplies RENK gear units and slide bearings, which can be fitted for these sensors.

Gas plants, refineries, petrochemical complexes and power stations in the Kingdom depend on protection systems on their large machines. Both missed faults and spurious trips are expensive.
Typical measurements
| Measurement | Purpose |
|---|---|
| Radial shaft vibration (X and Y probes) | Detects unbalance, misalignment, rubs and bearing problems |
| Axial position | Monitors thrust bearing wear and axial movement |
| Phase reference (keyphasor) | Supports diagnosis of vibration |
| Bearing metal temperatures | Early warning of lubrication or load problems |
| Casing vibration | Gear mesh and rolling bearing faults |
| Overspeed | Protects turbines and high-speed trains |
Getting protection right
Install proximity probes with the correct gap and on a clean, low run-out shaft area.
Place temperature sensors in the loaded zone of slide bearings.
Set alarms and trips from OEM data and machine history.
Use voting logic, such as two out of two or two out of three, to avoid single-sensor trips.
Test channels and trip paths at planned intervals.

Using the data
Send protection data to condition monitoring software for trend analysis.
Review trips and alarms with the vibration specialist before restart.
Compare data after overhauls with baselines.
Watch for slow changes that do not yet reach alarms; see slide bearings.
Coordinate with torsional and gear studies on new trains; see torsional vibration.
RENK from BTGC
RENK of Germany makes high-performance gear units, slide bearings and couplings. BTGC is the RENK partner in Saudi Arabia. See also API 613 gear units, vibration analysis and the rotating equipment page.
Questions buyers ask
What does API 670 cover? The specification of machinery protection systems for vibration, position, temperature and overspeed.
Why use voting logic for trips? To avoid shutting down a machine because of a single faulty sensor.
Can RENK bearings be supplied with temperature sensors? Yes, sensor provisions can be specified with the bearings and gear units.
Contact BTGC
Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.