Mill Drive Gear Units for Cement and Mining Plants

18.11.26 02:58 PM

In short: vertical roller mills and ball mills grind raw meal, cement, coal and ores with very high torque at low speed. Their gear units carry heavy, variable loads, often take the mill table's weight and grinding force, and run around the clock. Good lubrication, oil cooling and condition monitoring keep them reliable, and a failure can stop a whole cement line. BTGC supplies RENK gear units and spare parts.

RENK gear unit components

Cement plants and mineral processing sites in the Kingdom rely on a few large mills, so each mill drive is critical.

Common mill drive arrangements

Mill typeDrive arrangementNotes
Vertical roller millBevel-planetary gear unit under the grinding tableGear unit takes vertical grinding loads through a thrust bearing
Ball mill, girth gearPinion gear unit driving an open girth gearOpen gear lubrication is critical
Ball mill, central driveGear unit on the mill axisCompact, no open gearing

What makes mill drives demanding

  • High torque and shock from changing feed, mill vibration and start-up.

  • Large thrust loads on vertical mill gear units from the grinding force.

  • High oil temperatures in summer, so oil coolers and clean oil are essential.

  • Dust everywhere, which attacks seals and breathers.

Cement and mineral processing plant

Keeping them running

  • Monitor vibration, oil temperature, oil pressure and thrust bearing temperatures continuously.

  • Run regular oil analysis for wear metals and contamination.

  • Keep spare bearings and seals, and plan major inspections with the kiln shutdown.

  • For girth gears, see open gear lubrication.

  • Review torsional behaviour when changing motors or drives.

RENK from BTGC

RENK makes gear units for industrial drives, including mill drives, along with high-speed gears, slide bearings and couplings. BTGC supplies RENK in Saudi Arabia for enquiries, spare parts and service coordination. See also cement plant wear protection and the mining and minerals sector page.

Questions buyers ask

What usually fails in a mill gear unit? Bearings and gear teeth, often after lubrication or cooling problems.

Can an old mill drive be upgraded? Often, with a new gear unit designed for the same interface and higher rating.

Does BTGC supply spare parts for installed RENK units? Yes, through RENK, based on the unit serial number.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.