Air Supply for Pneumatic Conveying: Blowers or Compressors

18.11.26 01:10 PM

In short: pneumatic conveying moves powders and pellets through pipes with air. Dilute phase systems use high air velocity at low pressure, usually from blowers, while dense phase systems push slugs of material at higher pressure from compressors. The air supply must give steady flow at the pressure the line needs, with the right air quality, or lines block and product degrades. BTGC supplies Ingersoll Rand blowers and centrifugal compressors.

Ingersoll Rand centrifugal air compressor

Polymer plants in Jubail and Yanbu, cement plants, fly ash systems and fertiliser plants in the Kingdom move large tonnages by air.

Dilute or dense phase

FeatureDilute phaseDense phase
Conveying pressureLow, typically below about 1 barHigher, often several bar
Air velocityHighLow
Usual air sourceBlowersCompressors
Product damage and pipe wearHigherLower
Typical productsFree-flowing powders and pellets over shorter runsAbrasive or fragile products and longer runs

Sizing the air supply

  • Size flow on the conveying velocity needed at the pickup point, with margin for leaks and wear.

  • Size pressure on the line pressure drop at maximum rate, plus filters and valves.

  • Allow for hot inlet air in summer, which reduces the mass flow from blowers and compressors.

  • Choose oil-free air where contamination matters, as with polymers and food.

  • Dry and cool the air where moisture causes caking.

Piping in a polymer plant

Reliable operation

  • Watch conveying pressure, since rising pressure warns of a building blockage.

  • Use blow-off or variable speed for turndown rather than hard throttling.

  • Keep inlet filters clean, especially after dust storms.

  • Plan spares for critical lines; see blower selection and air quality classes.

Ingersoll Rand from BTGC

Ingersoll Rand makes centrifugal air compressors and blowers. BTGC supplies Ingersoll Rand in Saudi Arabia with spare parts and maintenance support. See also compressed air piping, the process and separation page and the petrochemicals sector.

Questions buyers ask

Can the plant air header feed a conveying system? Sometimes for small systems, but large systems usually need their own air supply to avoid pressure swings.

Why do conveying lines block? Air velocity too low, feed rate too high, or moisture causing build-up.

Is oil-free air needed? For polymers, food and many chemicals, yes.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.