Large Valves for Process Gas in Steel and Direct Reduction Plants

17.11.26 03:11 PM

In short: direct reduction and steel plants move huge volumes of hot, dusty process gas: reformed gas, reducing gas, top gas and fuel gas, often in lines of several metres diameter. Valves here must isolate safely for maintenance, control flow, and resist heat, dust and thermal cycling, all while being large enough to fit the duct. Fabricated triple-offset butterfly valves, gate valves and special isolation designs are used depending on temperature and tightness needs. BTGC supplies Krombach large-diameter and high-temperature valves.

Krombach-Armaturen valve range

Steel plants in the Kingdom use direct reduced iron and electric arc furnaces, with large gas systems that run continuously. Valve leaks on process gas lines are dangerous because many of these gases are toxic and flammable.

Typical gas valve duties

DutyValve considerations
Reducing gas to the shaft furnaceHigh temperature, tight isolation, refractory protection where needed
Top gas and recycle gasDust and moisture, fouling, large diameters
Fuel gas to reformer burnersControl and shutoff, safety interlocks
Isolation for maintenancePositive isolation with double block and bleed or blinds as required by safety rules

Selection points

  • Gas composition, temperature, pressure and dust load.

  • Required leakage rate and whether positive isolation is needed for entry.

  • Materials for heat and corrosion; see valve materials.

  • Actuation speed, fail-safe position and interlocks with the process.

  • Weight, supports and access for very large valves.

Steel plant

Maintenance tips

  • Clean dust deposits from seats and discs during stops.

  • Check seat tightness and stem packing at each shutdown.

  • Inspect refractory and insulation on hot gas valves.

  • Exercise valves that rarely move so they do not seize.

  • Keep records of operating torque to detect binding early.

Krombach from BTGC

Krombach-Armaturen of Germany builds triple-offset butterfly valves, fabricated gate and check valves, bottom drain valves and valves for extreme temperatures. BTGC is the Krombach partner in Saudi Arabia. See also hot gas isolation valves, position sensors in mills and the metal sector page.

Questions buyers ask

Can a butterfly valve give positive isolation for entry? Usually not on its own; safety rules often require double isolation with bleed, or blinds.

Why do top gas valves stick? Dust and moisture form deposits on seats and discs.

Can BTGC supply very large custom valves? Yes, Krombach fabricates valves to project sizes and specifications.

Contact the BTGC valve team

Email valves@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.