Screw Pump Maintenance: Wear, Clearances, Seals and Relief Valves

18.11.26 08:15 AM

In short: screw pumps move fuel oil, lube oil, crude and other viscous liquids smoothly and quietly, but their performance depends on tight clearances between the screws and the casing. As these clearances wear, more liquid slips back from discharge to suction and flow falls, especially with thin or hot liquids. Clean suction, no dry running, correct relief valve settings and timely overhauls keep screw pumps efficient for years. BTGC supplies Arai Pump screw pumps and spare parts.

Process piping and pumps

Power plants, refineries, ships, terminals and lube oil systems in the Kingdom run screw pumps continuously. Many wear out early because of dirt, dry running or wrong relief settings.

What to monitor

ParameterWhat a change suggests
Flow at set pressureInternal wear and slip
Power drawViscosity change, wear or blockage
Discharge pressure stabilityAir entry, cavitation or relief valve issues
Vibration and noiseBearing wear, misalignment or cavitation
Seal leakageSeal wear or damage from dry running

Preventing early wear

  • Fit and maintain suction strainers or filters sized for the pump.

  • Never run the pump dry; prime it and confirm suction before start-up.

  • Heat viscous liquids to the design temperature before starting.

  • Check the relief valve setting and that it returns to suction or tank as designed.

  • Keep coupling alignment within limits.

Oil and gas facility

Overhaul checks

  • Measure screw and casing or liner clearances against limits.

  • Inspect screw flanks for scoring and pitting.

  • Replace bearings, seals and timing gears where fitted.

  • Check shaft run-out and coupling condition.

  • Test performance after overhaul and record the baseline; see PD pumps for viscous fluids.

Arai Pump from BTGC

Arai Pump Mfg. Co., Ltd. of Japan makes screw pumps and rotary plunger pumps for fuel, lube oil and viscous fluids. BTGC is the Arai Pump partner in Saudi Arabia. See also fuel oil supply systems, lube oil systems and the rotating equipment page.

Questions buyers ask

Why does a screw pump lose flow over time? Wear increases internal clearances, so more liquid slips back to suction.

Can a screw pump run dry briefly? It should not; dry running quickly damages screws and seals.

Does BTGC supply Arai spare parts? Yes, screws, seals, bearings and complete pumps.

Contact BTGC

Email info@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.