In short: stem packing is the most common leak path on gate and globe valves. Flexible graphite rings seal well, but they consolidate over time and with heating and cooling, so gland stress falls and leaks start. Live loading with disc springs keeps the stress up between adjustments, and low-emission packing sets tested to API 622 and valves tested to API 624 cut fugitive emissions. Correct repacking practice matters as much as the packing itself. BTGC supplies Pacific Valves gate, globe and check valves and repairs valves in Jubail.

Refineries, gas plants and petrochemical complexes in the Kingdom run leak detection and repair programmes for fugitive emissions. Valve stems are among the largest sources found.
Why packing leaks
| Cause | Effect |
|---|---|
| Graphite consolidation | Gland stress falls over time |
| Thermal cycling | Packing relaxes after heating and cooling |
| Stem damage or poor finish | Scratches and corrosion open leak paths |
| Wrong installation | Gaps, wrong ring count or uneven compression |
| Over-tightening | High friction, stem wear and slow operation |
Ways to reduce leaks
Use die-formed graphite rings with anti-extrusion end rings.
Fit live loading with disc springs on valves with frequent thermal cycles.
Specify low-emission packing to API 622 and valves type-tested to API 624 or ISO 15848; see low-emission valves.
Check stem straightness and finish during repairs.
Follow the supplier gland torque values.

Repacking a valve correctly
Remove all old packing and clean the stuffing box and stem.
Inspect the stem and box for damage and measure dimensions.
Install rings one at a time, seating each before adding the next.
Tighten gland nuts evenly in steps to the specified torque.
Cycle the valve, re-check torque and record the work.
Pacific Valves from BTGC
Pacific Valves is the Crane ChemPharma and Energy brand for cast steel gate, globe and check valves in demanding refinery services. BTGC is the Pacific Valves partner in Saudi Arabia through Crane, with valve testing and repair at the Jubail service center. See also pressure seal bonnet repair, turnaround valve planning and the oil and gas sector page.
Questions buyers ask
What does live loading do? Disc springs keep pressure on the packing as it consolidates, reducing leaks.
What is API 622? A test standard for valve stem packing used to qualify low-emission packing.
Can BTGC repack valves? Yes, at the Jubail service center, as part of valve repair.
Contact the BTGC valve team
Email valves@btc-ksa.com or call +966 13 856 0528. Branches: Dammam, Jubail and Yanbu. Request a quote.